Simulation of Connecting Rod Using Finite Element Analysis
Keywords:
Simulation, Connecting rod, Finite element, Cero PTC, Connecting rod simulationAbstract
Numbers of connected rods are used in the assembly of petroleum engines, the task of connecting rod important of converting reciprocating motion of the piston into rotary motion of the crankshaft. In this work stress analysis at various individual tensile and compressive loads acting on connecting rod at different speed was done. Simulation was performed by using Cero PTC software to obtain stress distribution in the connecting rod at static condition.
Downloads
References
P. S. Shenoy and A. Fatemi, (2006, February).Dynamic analysis of loads and stresses in connecting rods. Journal of Mechanical Engineering Science. Vol. 220, pp 615-624.
M. Ranjbarkohan, M. R. Asadi and B. N. Dardashti. (2011, August). Stress analysis of connecting rod of nissan Z24 engine by the finite elements method. Aust. J. Basic and Appl. Sci.5(12), pp. 2084-2089.
B.Kuldeep, L.R. Arun and F.Mohammed. (2013, June). Analysis and optimization of connecting rod using alfa SiC composites. International Journal of Innovative
Research in Science, Engineering and Technology, 2(6), pp. 2480- 2487.
A. D. Dantale and A. J.Keche. (2014). Fatigue life validation and analysis of connecting rod. International Journal of Hybrid Information Technology. 7(6). pp. 423-432.
F. Desil, K. Jagtap. And A. Deshpande. (2014, July).Numerical and experimental analysis of connecting fod. International Journal of Emerging Engineering Research and Technology. 2(4,) pp 242-249.
N. U. Thakare, N. D. Bhusale, R. P. Shinde, M. M. Patil (2015,April).Finte element analysis of connecting rod using ansys. International Journal of Advances in Science Engineering and Technology, 3(2), pp 82-87.
