Effect of Addition of Alccofine on Coal Bottom Ash Concrete  Properties

Mohit Choudhary; Susheel Kumar

doi:10.55524/ijircst.2023.11.4.10

Authors

Mohit Choudhary M. Tech Scholar, Department of Civil Engineering, Sant Baba Bhag Singh University, Punjab, India Author
Susheel Kumar Assistant Professor, Department of Civil Engineering, Sant Baba Bhag Singh University, Punjab, India Author

DOI:

https://doi.org/10.55524/ijircst.2023.11.4.10

Keywords:

Concrete, Sustainability, Green Environment, Waste Management, Compressive Strength

Abstract

The effect of addition of ultra-fine material i.e. Alccofine on the properties of coal bottom ash assisted concrete has been studied in this study. Alccofine is added in steps in the 40% bottom ash concrete to revive the properties of bottom ash concrete. A proportion of 5 to 20% has been added as an alternative to cement. Results showed that replacement of cement with Alccofine has improved the compressive strength of the concrete.

Downloads

Download data is not yet available.

References

L. Poudyal and K. Adhikari, “Environmental sustainability in cement industry: An integrated approach for green and economical cement production,” Resour. Environ. Sustain., vol. 4, p. 100024, 2021.

C. Scope, M. Vogel, and E. Guenther, “Greener, cheaper, or more sustainable: Reviewing sustainability assessments of maintenance strategies of concrete structures,” Sustain. Prod. Consum., vol. 26, pp. 838–858, 2021.

Al-Fakih, B. S. Mohammed, M. S. Liew, and E. Nikbakht, “Incorporation of waste materials in the manufacture of masonry bricks: An update review,” J. Build. Eng., vol. 21, pp. 37–54, 2019.

S. Shahidan et al., “Physical and mechanical properties of self-compacting concrete containing superplasticizer and metakaolin,” in IOP Conference Series: Materials Science and Engineering, 2017, vol. 271, no. 1, p. 12004.

M. Rafieizonooz, J. Mirza, M. R. Salim, M. W. Hussin, and E. Khankhaje, “Investigation of coal bottom ash and fly ash in concrete as replacement for sand and cement,” Constr. Build. Mater., vol. 116, pp. 15–24, 2016.

K. Muthusamy, M. H. Rasid, G. A. Jokhio, A. Mokhtar AlbshirBudiea, M. W. Hussin, and J. Mirza, “Coal bottom ash as sand replacement in concrete: A review,” Constr. Build. Mater., vol. 236, p. 117507, 2020, doi: https://doi.org/10.1016/j.conbuildmat.2019.117507.

Y. Tian, X. Zhou, Y. Yang, and L. Nie, “Experimental analysis of air-steam gasification of biomass with coal bottom ash,” J. Energy Inst., vol. 93, no. 1, pp. 25–30, 2020.

L. Barcelo, J. Kline, G. Walenta, and E. Gartner, “Cement and carbon emissions,” Mater. Struct., vol. 47, no. 6, pp. 1055–1065, 2014.

E. Benhelal, G. Zahedi, E. Shamsaei, and A. Bahadori, “Global strategies and potentials to curb CO2 emissions in cement industry,” J. Clean. Prod., vol. 51, pp. 142–161, 2013.

Y. Aggarwal and R. Siddique, “Microstructure and properties of concrete using bottom ash and waste foundry sand as partial replacement of fine aggregates,” Constr. Build. Mater., vol. 54, pp. 210–223, 2014.

H. Zhou et al., “Towards sustainable coal industry: Turning coal bottom ash into wealth,” Sci. Total Environ., vol. 804, p. 149985, 2022, doi: https://doi.org/10.1016/j.scitotenv.2021.149985.

C. Jaturapitakkul and R. Cheerarot, “Development of bottom ash as pozzolanic material,” J. Mater. Civ. Eng., vol. 15, no. 1, pp. 48–53, 2003.

H. Kurama and M. Kaya, “Usage of coal combustion bottom ash in concrete mixture,” Constr. Build. Mater., vol. 22, no. 9, pp. 1922–1928, 2008.

H. Yıldırım and T. Özturan, “Impact resistance of concrete produced with plain and reinforced cold-bonded fly ash aggregates,” J. Build. Eng., vol. 42, p. 102875, 2021, doi: https://doi.org/10.1016/j.jobe.2021.102875.

E. Güneyisi, M. Gesoğlu, İ. Altan, and H. Ö. Öz, “Utilization of cold bonded fly ash lightweight fine

aggregates as a partial substitution of natural fine aggregate in self-compacting mortars,” Constr. Build. Mater., vol. 74, pp. 9–16, 2015, doi: https://doi.org/10.1016/j.conbuildmat.2014.10.021.

O. H. Oren, A. Gholampour, O. Gencel, and T. Ozbakkaloglu, “Physical and mechanical properties of foam concretes containing granulated blast furnace slag as fine aggregate,” Constr. Build. Mater., vol. 238, p. 117774, 2020, doi: https://doi.org/10.1016/j.conbuildmat.2019.117774.

L. Mengasini, M. Mavroulidou, and M. J. Gunn, “Alkali activated concrete mixes with ground granulated blast furnace slag and paper sludge ash in seawater environments,” Sustain. Chem. Pharm., vol. 20, p. 100380, 2021, doi: https://doi.org/10.1016/j.scp.2021.100380.

G. Chand, S. K. Happy, and S. Ram, “Assessment of the properties of sustainable concrete produced from quaternary blend of portland cement, glass powder, metakaolin and silica fume,” Clean. Eng. Technol., vol. 4, p. 100179, 2021, doi: https://doi.org/10.1016/j.clet.2021.100179.

Habibi, A. M. Ramezanianpour, M. Mahdikhani, and O. Bamshad, “RSM-based evaluation of mechanical and durability properties of recycled aggregate concrete containing GGBFS and silica fume,” Constr. Build. Mater., vol. 270, p. 121431, 2021, doi: https://doi.org/10.1016/j.conbuildmat.2020.121431.

B. Jindal, D. Singhal, S. K. Sharma, and D. K. Ashish, “Improving compressive strength of low calcium fly ash geopolymer concrete with alccofine,” Adv. Concr. Constr., vol. 5, no. 1, p. 17, 2017.

Singhal, B. B. Jindal, and A. Garg, “Mechanical properties of ground granulated blast furnace slag based geopolymer concrete incorporating alccofine with different concentration and curing temperature,” Adv. Sci. Eng. Med., vol. 9, no. 11, pp. 948–958, 2017.

R. B. Tangadagi, M. M, D. Seth, and P. S, “Role of mineral admixtures on strength and durability of high strength self compacting concrete: An experimental study,” Materialia, vol. 18, p. 101144, 2021, doi: https://doi.org/10.1016/j.mtla.2021.101144.

R. Muduli and B. B. Mukharjee, “Effect of incorporation of metakaolin and recycled coarse aggregate on properties of concrete,” J. Clean. Prod., vol. 209, pp. 398–414, 2019, doi: https://doi.org/10.1016/j.jclepro.2018.10.221.

H. Bilal, T. Chen, M. Ren, X. Gao, and A. Su, “Influence of silica fume, metakaolin & SBR latex on strength and durability performance of pervious concrete,” Constr. Build. Mater., vol. 275, p. 122124, 2021, doi: https://doi.org/10.1016/j.conbuildmat.2020.122124.

M. Singh and R. G. Siddique, “Effect of coal bottom ash on strength and durability properties of concrete.” 2015. [26] L. B. Chun, K. J. Sung, K. T. Sang, and S. T. Chae, “A study on the fundamental properties of concrete incorporating pond-ash in Korea,” in The 3rd ACF international conference-ACF/VCA, 2008, pp. 401–408. [27] H. K. Kim and H. K. Lee, “Use of power plant bottom ash as fine and coarse aggregates in high-strength concrete,” Constr. Build. Mater., vol. 25, no. 2, pp. 1115–1122, 2011, doi: https://doi.org/10.1016/j.conbuildmat.2010.06.065.